Happy embroidery

Turn any picture into an embroidery design for your Happy

Happy commercial and compact multi-needle machines read DST. Turn a picture into a DST, check the stitch count and trims before paying, and set your needles from the production sheet.

Try it with your picture

Good Vibes retro patch with a striped sunset and a palm tree – Stitched

Good Vibes retro patch with a striped sunset and a palm tree – Your picture

Your pictureStitched

Free preview · no account needed

Drop a picture – see it stitched for your Happy

No account needed for the preview: your picture is digitized right here in your browser. You only use a credit when you download.

Drop your picture hereor click to choose · PNG, JPG, WEBP, SVG · up to 15 MBYou can also paste an image (Ctrl/⌘ V).

Machine files:.PES.DST.JEF.EXP

Your picture stays on your device until you choose to save it.

Which file format does my Happy machine read?

.DST

Happy machines read .DST, the standard commercial embroidery format that nearly every multi-needle machine understands. A DST holds stitches, jumps and colour stops but no thread colours, so you assign needles on the machine. The stitches are as precise as in any other format: all of them store positions in 0.1 mm steps.

All about the .DST format

What size designs can my Happy sew?

The frame on your Happy sets the limit, not the file. Round tubular hoops are sold by diameter (a 12 cm hoop fits about an 80 × 80 mm design), cap frames take designs about 50–60 mm tall and 110–130 mm wide, and the largest flat frames on single-head machines reach around 360 × 500 mm.

Typical frames on Happy and other commercial machines
Hoop	Sewing field	Typical models and uses
Round tubular hoop, 12 cm	About 80 × 80 mm of design	Small logos, sleeves and pockets
Round tubular hoop, 15 cm	About 100 × 100 mm of design	Left chest logos, usually 75–100 mm wide
Cap frame (270°)	About 50–60 mm tall × 110–130 mm wide	Structured caps; low-profile caps leave less height
Largest flat frames (single-head)	Around 360 × 500 mm	Jacket backs and large panels

Frame sizes depend on the machine model and the frame maker, so check the frame list for your machine. Round hoops are sold by diameter: the largest square that fits is the diameter divided by 1.41, minus a margin.

How do I get a design onto my Happy?

Copy the .dst to a USB stick and load it into the machine's memory, or send it from your embroidery software. Assign needles to the colour stops, make sure the machine's trim setting matches how DST writes trims, and trace the outline to check the design clears the frame.

1Unzip the download and pick the .dst file.
2Load it into the machine from a USB stick or your embroidery software.
3Assign needles to the colour stops from the production sheet.
4Check the trim setting and trace the outline, then start.

Can I use the same DST on a Happy and a Tajima?

Yes. DST is shared across commercial brands, so one file sews the same stitches on Happy, Tajima, Ricoma or Barudan machines. Check that each machine's trim setting matches how the file writes trims, and set the needles from the colour list.